Publicité
Les langues disponibles
Les langues disponibles
27
The motor runs
continuously
A layer of frost
occurs in the
compartment
Temperature
inside is too warm
Temperature
inside is too cold
Doors can't be
closed easily
Water drips on
the floor
The light is not
working
Ice is not
dispensing
It is normal to frequently hear the sound of the motor, it will need to
run more during following circumstances:
Temperature setting is set colder than necessary.
Large quantity of warm food has recently been stored within the
appliance.
The temperature outside the appliance is too high.
Doors are kept open too long or too often.
After your installing the appliance or it has been switched off for a
long time.
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation. Ensure
the door can be fully closed. T o remove the frost, please refer to the
cleaning and care chapter.
You may have left the doors open too long or too frequently; or the
doors are kept open by some obstacle; or the appliance is located
with insufficient clearance at the sides, back and top.
Increase the temperature by following the"Display controls" chapter.
Check whether the top of the refrigerator is tilted back by
to allow the doors to self close, or if something inside is preventing
the doors from closing.
The water pan (located at the rear bottom of the cabinet)
may not be properly leveled, or the draining spout under
neath the top of the compressor depot may not be properly
positioned to direct water into this pan, or the water spout
is blocked. You may need to pull the refrigerator away from
the wall to check the pan and spout.
Check if the refrigerator is power-off for a long time, this
may cause the ice in the bucket to melt into water,
and flow to the floor .
The LED light may be damaged. Refer to replace LED lights in
cleaning and care chapter.
The control system has disabled the lights due to the door being
kept open too long, close and reopen the door to reactivate the
lights.
Did you wait for 10 hours after installation of the water supply line
before making ice? if it is not sufficiently cool, it may take longer to
make ice, such as when first installed.
Is the water storage box installed accurately? Make sure
there is enough water in the water storage
Did you manually stop the ice making function? Make sure you
10-15
mm
box..
Publicité
