Hisense RB435N4WCE Livret D'instructions page 41

9
Installing your new appliance
Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation of appliance
In order to improve efficiency of
the cooling system and save
energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.For
this reason,sufficient clear space should
be available around the refrigerator.
Suggest: It is advisable for there to be
50-70mm of space from the back to the
wall,at least 100mm from its top,at least
100mm from its side to the wall and a
clear space upfront to allow the doors to
open 115°.As shown in follow
diagrams.
115
831
Note:
This appliance performs well within
●
the climate class from SN to ST
showed in the table below.It may not
work properly if being left at a
temperature above or below the
indicated range for a long period.
Climate class Ambient temperature
+10°C to +32°C
SN
N +16°C to +32°C
ST +16°C to +38°C
Stand your appliance in a dry place to
●
avoid high moisture.
Keep the appliance out of direct
●
sunlight, rain or frost. Stand the
appliance away from heat sources such
as stoves,fires or heaters.
Leveling of appliance
For sufficient leveling and air
●
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted.You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt the
●
top backwards by about 10mm .