Publicité
Les langues disponibles
Les langues disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nuts (D) and
washers (C) from the new faucet (A).
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Slide the washers (C) over threaded rods. Use
the lock nuts (D) to secure the washers (C).
NOTE: If the sink is uneven, use silicone under the
gasket (B).
2
C
D
A
1
B
2
2
Preparing the pop-up assembly
□
Remove the pop-up stopper (E) and drain
ange (F) from the drain body (I).
D
4
E
I
F
Publicité
