MIRKA 1242 M Mode D'emploi page 86

en
[original instructions]
The hose diameter and the setting for suction hose diameter must be the same: Ø 21, 27, 32, 36, 38 mm .
3.2 Auto-On / Off socket outlet for power tools
CAUTION
Appliance socket
The appliance socket is designed for electrical auxiliary equipment; see technical data for reference .
• Prior to plugging in an appliance, always switch off the machine and the appliance that is to be connected .
• Read the operating instructions for the appliance to be connected and observe the safety notes contained in these .
An earthed appliance socket is integrated in the machine . An external power tool can be connected there . The
socket features permanent power on when the switch is set to the
extension cord . Australia: The socket has a 5 Amp thermal fuse to protect the machine against overload . If the power
consumption gets too high the thermal fuse activates and cut off the power on the socket outlet . The thermal fuse can
be deactivated again by pressing the knob .
In position , the machine can be switched on and off from the connected power tool . Dirt is picked up from the
source of dust immediately . To comply with regulations, only approved dust-producing tools should be connected .
The maximum power consumption of the connected electrical appliance is stated in the "Specifications" section .
Before turning the switch to position
3.3 Push & Clean
The "PC" machine is equipped with a semiautomatic filter cleaning system, Push & Clean . The filter cleaning system
must be actuated when the suction performance starts to fade . Regular use of the filter cleaning feature maintains
suction performance and increases the lifetime of the filter . For instructions, see the quick reference guide .
3.4 AFC – Auto Filter Cleaning
The "AFC" machine is equipped with an automatic filter cleaning system, Auto Filter Cleaning . A frequent cleaning cycle
will automatically run during operation to ensure that suction performance is always at its best .
If suction performance decreases or in very dusty applications, a manual filter cleaning operation is recommended:
• Switch off the machine .
• Close the nozzles or suction hose opening with the palm of your hand .
• Turn the switch to position "I" and let the machine operate at full speed for approx . 10 seconds with the suction hose
opening closed .
If suction power is still reduced take out the filter and clean it mechanically or replace the filter . For certain applications,
such as wet pick-up, it is recommended to turn off the Auto Filter Cleaning system . For details see chapter 3 .1 .
3.5 Antistatic connection
CAUTION
The machine is equipped with an antistatic system to discharge any static electricity that may develop during dust
pick-up .
86
Mirka® Dust Extractor • 1230M & 1242 M • 230 V / 100–120 V • PC & AFC
Turn to I: Activate the dust extractor .
Turn to : Stop the dust extractor . Permanent power on socket .
Turn to I: Activate Auto-On/Off operation .
Turn to I + AFC Off: Activate the dust extractor with deactivated Auto Filter Cleaning .
Turn to sander + Off: Activate Auto-On/Off operation with deactivated Auto Filter Cleaning .
Speed control operation on separate rotary knob .
, ensure that the tool connected to the appliance socket is switched off .
position, i .e . the machine can be used as an