Power Base Operating Guide; Circuit Breakers; Motor Locks; C.performance Control Settings - Sunrise Medical Zippie Z-Bop Mode D'emploi

E N G L I S H
IX. POWER BASE OPERATING GUIDE
A. CIRCUIT BREAKERS
1. Notes:
Your Zippie Z-Bop has a circuit breaker protruding through the shroud cover at the right
rear of the chair.
• In the unlikely event of a short circuit or heavy overload, all power to your chair will be
shut off.
• To reset your chair, depress the circuit breaker button located at the rear corner of the
chair. A few minutes wait is required before the circuit breaker will reset.
2. Repeated Shutdown:
If the chair continues to shut down after resetting, have it serviced by a supplier.
B. MOTOR LOCKS
Disconnect the motor locks when you need to manually push the chair.
(For example, in an emergency, or if batteries fail).
1. Do not disengage motor locks unless power to the chair is off.
2. With either one or both brakes released, the chair will not operate and the
battery charge indicator will flash 9 bars rapidly (if power to the chair is on.)
3. Be aware that the chair will not have brakes in the free-wheel position.
4. Make sure that the person pushing the chair has full control when motor locks
are disengaged.
1. Release Motor Locks
a. At the back of the chair you will find two levers marked in red.
b. Pull the brake releases backward.
2. Engage Motor Locks
a. At the back of the chair you will find two levers marked in red.
b. Push the brake releases forward. (A).
C. PERFORMANCE CONTROL SETTINGS
Q-NOTE– Seek advice regarding checking and adjusting settings.
1. It is vital to match control settings to your level of function and ability.
2. Consult your health care professional and your supplier to select the best control set-
tings for you.
3. Check and adjust the settings every six to twelve months.
Adjust the control settings immediately if you notice any change in your ability
to:
• Control the joystick.
• Avoid running into objects.
4. Control Settings can be adjusted by your dealer.
D. QUICKIE HAND HELD PROGRAMMER

OR QUICKIE PC SETUP STATION

Program settings beyond the ability of the user can result in serious injury.
Consult your health care advisor before you alter settings.
The Quickie Hand Held Programmer or Quickie PC Set-Up Station lets you adjust the con-
trol settings of the Rhythm. Listed below are a few of the many settings that can be adjust via
the Quickie Hand Held Programmer or Quickie PC Setup Station. (See Quickie Owners
Manual for full programmable parameters.)
932213 Rev. A
WARNING
WARNING
(Optional)
WARNING
22
I X . P OW E R B A S E O P E R AT I N G G U I D E
A
Circuit
Breaker