Explore Scientific WSH4005-CM3LC2 Mode D'emploi page 3

PRODUCT OVERVIEW
1. Press [ SNZ / LIGHT ] to activate and adjust the
backlight or to activate the snooze function to
delay the alarm for 5 minutes.
2. While in normal display, press [ UP ] to select
°C or °F. While in setting mode, press [ UP ] to
increase one unit, press and hold to increase
rapidly.
3. While in normal display mode, press and hold
[ DOWN ] to initiate or exit RCC receiving*. While
in setting mode, press [ DOWN ] to decrease
one unit, press and hold to decrease rapidly.
4. Press and hold [ CH ] to clear present channel.
5. While in normal display, press [ SET ] to display
alarm time, then press and hold [ SET ] to enter
alarm setting mode. While in time display mode,
press and hold [ SET ] to enter time setting mode.
6. Press [ MAX/MIN ] once to check max. and min.
temperature and humidity. While displaying max.
and min. data, press and hold [ MAX/MIN ] to
clear all memory.
7. Wall Mount.
8. Battery compartment.
9. Table stand.
OUTDOOR SENSOR
1. Battery compartment door.
2. Battery compartment.
3. RESET button (reset all settings).
4. Channel switch.
5. Data transmission light
*RCC function is not avaiable in some territories, including but not limited to Australia.
1
2 2
2 3
5
4
7
8
9
1
EN
IT
DE
FR
2 5
ES
2 6
NL
3
RESET
4
2
3