Domo DO1087K Mode D'emploi page 24

9. Place the portafilter under the brew group. Hold the handle so that it connects correctly to the open-
lock symbol
10. Turn it slowly to the right, to the closed-lock symbol
11. When the appliance is preheated, the indicator light in the espresso button will light up. Turn the
selector switch to the coffee symbol.
12. Place a cup on the drip tray and press the espresso button. By default, the espresso button is for a
40 ml cup. If you want a double espresso or two cups of coffee, press the espresso button for three
seconds. The standard amount of a double espresso is 80 ml. The coffee will continue to flow and the
indicator light on the button will flash. The indicator light is blue for an espresso and red for a double
espresso. When the coffee has finished flowing, the machine stops automatically and the indicator
light on the button lights up. If you want to stop the machine sooner, press the espresso button
again while the coffee is flowing.
13. Remove your cup from under the portafilter. Turn the selection button to the middle position "0".
A small amount of water may be deposited into the drip catcher via a hose at the bottom of the
appliance. This is normal.
14. Remove the portafilter from the appliance. Place the retainer clip against the filter and bang the
coffee grounds out of the filter.
15. Clean the portafilter and dry it off for the next use.
Tips:
· If you turn the selector switch to the middle position '0' when the coffee is ready, it will be easier to
remove the portafilter.
· The drip catcher can be removed to fit a large cup under the portafilter. Be sure that the drip tray is
replaced before turning the selection button to the middle position "0". A small amount of water may
be deposited into the drip catcher via a hose at the bottom of the appliance when turning it to this
position.
MILK
1. Put the plug in the socket and press the on-off button.
2. Turn the selection button to the middle position "0". Press the steam button to heat up the
appliance. The indicator light will flash. Once the indicator light stays on, the appliance is heated.
3. While it is heating up, a small amount of water may end up in the drip catcher. This is normal.
4. Fill a small jar with cold milk (not hot!). Be careful not to fill it too full. When the milk foams, it
increases in volume. Place the jar under the steam pipe.
5. Turn the selection button to the steam symbol.
6. Immerse a few millimetres of the steam pipe into the milk. To get creamier foam, immerse the
steam pipe in the milk and rotate the jar with slow movements from the bottom to the top.
7. Once you have the desired amount of foam, turn the selection button to the middle position "0".
8. Clean the steam pipe after each use. Caution: the steam pipe may still be hot.
24
DO1087K
on the appliance and fits into the groove.
on the appliance.