Publicité
See fig. 3.1-3.6
Insert the connector pipes with the o-rings of the upper arm of the shower (19) into the lower pipe of the shower (15). Set the parts (19) and (15) in the correct position and fit the screws (18) using a hexagon key
(B). Set the fixing element (22) in the correct position.
Slide the assembly holder (27) onto the connector (24). Slide the lower end of the arm of the shower (15) onto the connector pipe with the o-ring (7) of the shower body (A1).
Set the installation holder (27) correctly on the wall (see fig. 3.3) and mark the 2 points for installing the wall plugs. Slide out the complete shower arm from the connector pipe (7) of the shower body and place it
on the side, slide the installation holder (27) from the connector (24).
Drill 2x Ø 6 mm holes (see fig. 3.3), insert wall plugs (29) to the holes and attach the installation holder (27) to the wall.
Put the rosette ring (25) with gasket (26) on the connector (24). Slide the lower end of the arm of the shower (15) onto the connector pipe with o-ring (7) of the shower body (A1) and slide the connector (24) into
the installation holder (27) Set the complete shower arm in the correct position and screw in the screws (18) and (28) using a hexagon key (B). Slide the rosette ring (25) with its gasket (26) onto the installation
holder (27). Slide the rosette ring to the finishing wall.
Screw the shower header nut (32) onto the connector (21) in the upper shower (19). Pay attention to the correct position of the flat gasket (31) in the shower head nut (32).
3.1
3.2
3.3
Rev. 9 May 2017
Publicité
