Publicité
Les langues disponibles
Les langues disponibles
24
Problem
The compressor does not
start immediately after
pressing the IntensiveCool‐
ing, or after changing the
temperature.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze or Intensi‐
veCooling function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The IntensiveCooling
function is switched on.
There is no cold air circu‐
lation in the appliance.
Solution
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or In‐
tensiveCooling manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "FastFreeze
or IntensiveCooling function".
Keep the Mode pressed for
approximately 10 seconds un‐
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Store less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "IntensiveCooling
function".
Make sure that there is cold
air circulation in the appliance.
Publicité
