Pit Boss PB200 Portable Instructions Et Utilisation page 5

PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts
are present. Compare parts with package contents list and diagram above. If any
part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement parts.
• Your Portable Gas Grill is pre-assembled. The only assembly required is to place
the flame tamers, cooking grid and control knobs into the grill.
• Estimated Assembly Time: 5 minutes.
Warning: this appliance is not intended for and should never be used as a heater.
ASSEMBLY INSTRUCTIONS
1. Remove all the packing materials and move grill close to a desired location.
2. Place on the control knobs as shown in Fig. 1. Push and turn the knob and check
for sparks.
8
Figure 1
ASSEMBLY INSTRUCTIONS
3. Attach the regulator with the 38 inch hose to the propane cylinder by turning the
regulator handle clockwise as shown in Fig. 2. If the outdoor cooking appliance is
not in use, the gas must be turned "OFF" at the Liquid Propane cylinder.
Check all gas supply fittings for leaks before each use. Do not use the grill until all
connections have been checked and do not leak (see "Leak Testing" instructions on
page 6).
Figure 2
4. Place the portable grill on the desk as shown in Fig. 3.
Note: This portable grill is used with a 38" gas hose, we suggest to use this grill on
a 3 foot high table.
Figure 3
9