Publicité
Les langues disponibles
Les langues disponibles
<
<
N
N
O
O
T
T
E
E
>
>
In such cases it is advisable to use the Walk Test function and check the outcome on the App and portal where available and / or on the
system's local devices (eg keyboards).
Mounting and installation method
Step 1: After having performed the Walk Test to confirm that the detector is within the coverage range, select corner or surface
mounting.
Step 2: Loosen the screws and remove the cover.
Step 3: According to the user's preferences, mount the detector in the required position with or without rotating bracket.
MOUNTING WITHOUT ROTATING BRACKET
The rear base of the detector is provided with a hole arrangement when the plastic is thinner to allow mounting. The two hole
arrangements (A) are used to fix on a surface while the four hole arrangements (C) are used for fixing in a corner, as shown in the
following figure.
<
<
N
N
O
O
T
T
E
E
>
>
After having perforated the hole arrangements, check that the device is waterproof and restore waterproofing, if
necessary, e.g. with silicone.
Surface
mounting
1) Perforate the appropriate hole arrangements on the cover of the base. Use arrangements "A" for
mounting on surface. Use arrangements "C" for mounting in corner.
2) Using the template for the hole,make two holes in the flat surface or four holes in the corner
surface.
3) Insert the anchor bolts if the device is fixed to plaster or bricks.
4) Install the base cover in the anchor bolt with the mounting screws provided.
5) Reposition the upper cover on the base and firmly press the upper part until it clicks (as shown on
the right).
6) Tighten the locking screw.
MOUNTING WITH ROTATING BRACKET
A rotating bracket is provided to allow a flexible mounting option. This allows a rotating bracket to be fixed to a surface/in a corner and
to an arm of the bracket to be fixed to the detector. Once installed, the detector may be separated easily from the bracket to replace
the batteries, for example, and then fixed back again with equal ease. This also makes it possible to adjust the horizontal detector for
better coverage.
1) Using the rotating shaft as template, make holes in the mounting site, either on a
surface or in a corner: 2 holes in position B for a surface, 4 holes in position D
for an angle.
2) Insert the anchor bolts if the device is fixed to plaster or bricks.
3) Fasten the rotating bracket in the anchor bolts with the flat side in direction of the
wall. The arm of the bracket must face towards the person performing the
mounting operation, with the joint on top.
4) Fasten the arm of the bracket to the cover of the base of the detector with the
pointy ends facing the opposite directions with respect to the detector, with the
joint on top.
5) Arrange the detector on the hooks of the rotating bracket.
6) Adjust the detection angle arranging the arm of the bracket on one of the holes of the top of the rotating bracket then tighten
the top screw as shown.
6
Fastening screw
Corner
mounting
Fastening screw
DS1051-032
Publicité
