Ariston MIROS Serie Manuel D'installation page 17

AND CAREFULLY BEFORE INSTALLING THE APPLIANCE
NORM
Make sure the installation site and any systems to which the device
must be connected comply with the applicable regulations.
When drilling the wall, take care not to damage any electrical wiring or
existing piping.
Protect connection piping and cables so as to prevent damage to them.
Use manual tools and equipment that are suitable for the intended use
(in particular, ensure that the tool is not worn and that the handle is
intact and securely fi xed); use them correctly and prevent them from
falling from a height. Put them safely back in place after use.
Use electrical equipment suitable for the intended use (in particular,
make sure that the power supply cable and plug are intact and that the
parts featuring rotary or reciprocating motion are fastened correctly);
use this equipment correctly; make sure no equipment could fall from a
height. Disconnect it and put it safely back in place after use.
Make sure that any portable ladders are securely positioned, that they
are strong enough, that the steps are intact and not slippery, that the
ladders are not moved with someone on them and that someone super-
vises at all times.
Make sure any rolling ladders are positioned securely, that they are
suitably resistant, that the steps are intact and not slippery, that the
ladders are fi tted with handrails on either side of the ladder and para-
pets on the landing.
During all work carried out off the fl oor (generally at a height above
two metres or 6 feet), make sure that parapets are used to surround
the work area or individual harnesses designed to prevent falls, and
that the space covered during any accidental fall is free from dangerous
obstacles, and that any impact upon falling is cushioned by semi-rigid
or deformable surfaces.
During all work procedures, wear individual protective clothing and
equipment.
All operations on the inside of the appliance must be performed with
the necessary caution in order to avoid sudden contact with the sharp
parts.
Recharge the refrigerant gas in accordance with the instructions pro-
vided on the product safety data sheet, wearing protective clothing,
avoiding violent outlets of gas from the tank or from the system's con-
nections.
Do not direct the air fl ow towards gas hobs or gas stoves.
Do not install the external unit in places where it could constitute a risk
or an obstruction to the passing of people, or where it could disturb
people due to the noise it makes, the heat or air fl ow.
Do not install the external unit in high positions
CAUTION
READ THIS MANUAL FULLY
RISK
Electrocution caused by contact with live
wires that have been incorrectly installed.
Electrocution caused by exposure to live
wires. Explosions, fi re or intoxication due to
gas leaks from damaged pipes.
Electrocution caused by exposure to live
wires. Cold burns due to gas leaking from
damaged piping.
Personal injury from the falling splinters or
fragments, inhalation of dust, shocks, cuts,
pricks and abrasions.
Personal injury from electrocution, fl ying
splinters or fragments, inhalation of dust,
shocks, cuts, pricks, abrasions, noise and
vibration.
Personal injury caused by falling from
heights or shearing (stepladders shutting
accidentally).
Personal injury caused by falling from a
height.
Personal injury due to impact, tripping and
wounds.
Personal injury caused by electrocution,
fl ying splinters or fragments, inhalation of
dust, shocks, cuts, puncture wounds, abra-
sions, noise and vibration.
Personal injury from cuts, pricks and abra-
sions.
Personal injury from cold burns.
Explosions, fi res or intoxication from the
discharge of gas leaking from the burner
nozzle once the air fl ow has put the fl ame
out.
Personal injury from contusions, stumbling,
noise and excessive ventilation.
injuries to things or people
GB
17