Parkside PFBS 160 C3 Traduction Des Instructions D'origine page 16

♦ To lock the spindle, push the spindle lock
back onto the flexible shaft.
♦ Use the combination spanner
tensioning nut on the flexible shaft.
Fit the accessory and retighten the tensioning
nut .
Stand for the multi-tool
♦ Screw the stand
assembly .
NOTE
► Depending on the desired attachment onto a
vertical or horizontal surface, you can screw
the stand into the clamping assembly in
two different positions.
♦ Screw the clamping assembly
of a work bench or table whose thickness is at
most 60 mm.
♦ The stand is height-adjustable. Undo the
upper part of the stand
clockwise (−). Pull out the tube to the maximum
height and lock it again by turning it clockwise
(+).
♦ The mount is also height-adjustable; turn the
black thread anticlockwise. After you have set
the mount to the correct height, tighten the
thread by turning in the opposite direction.
♦ Fix the appliance onto the mount
stand using the metal bracket
mount can be turned 360°.
■ 12 │ GB │ IE
to undo the
into the clamping
onto the edge
by turning it anti-
of the
. The
Router cage
With this attachment, the appliance is particularly
suitable for cutting special forms (holes for plugs,
etc.).
♦ Insert the milling bit
section "Changing/inserting the tool/collet
chuck".
♦ Ensure that the shaft of the bit protrudes out of
the collet chuck by about 16 mm.
♦ Screw the union nut
appliance and store it carefully.
♦ Screw the router cage
♦ To set the correct working height, undo the
locking screw and adjust the foot of the
router cage to the desired size.
♦ Afterwards, retighten the locking screw
as described in the
anticlockwise off the
onto the appliance.
.
ca. 16 mm
PFBS 160 C3