Control Panel Leds; Comfort Mode - DeLonghi Ghibli Série Mode D'emploi

4.1 USING THE RADIATOR FROM THE CONTROL PANEL:
Clogged filter light
LED "L1"
LED "L2"
LED "L3"
LED "L4"
LED "L5"
MANUAL Button

CONTROL PANEL LEDS

"L1" Cycle/Fan
"L2" Comfort/Chrono
"L3" Pilot wire
"L4" Anti-freeze
"L5" Standby
4.1.1 ON/STANDBY
To turn the appliance on, place the main
switch on the control panel in the "I" position.
LED "L5" comes on.
To turn the appliance off completely, place the
switch in the "0" position.
The appliance can be controlled by the infrared remote
control with LCD display or manually by the control panel.
Infrared Receiver
/ Green
/ Green
Green
Green
Red
CYCLE
15 min
4.1.2 MANUAL BUTTON
The MANUAL button can be used to select the principal
operating modes without using the remote control.
Press the "MANUAL" button to select the following mo-
des in sequence: "Comfort", "Pilot Wire", "Anti-Freeze",
"Standby". The corresponding LED lights up.

4.1.3 COMFORT MODE

"Comfort" mode is designed for normal use of the appliance
to heat the room.
To activate "Comfort" mode, press the
"MANUAL" button until LED "L2" turns green.
The factory set temperature is 19 °C. To modify this
temperature, use the "+" and "-" buttons on the remote
control (where included).
41
Cycle Button
Fan button
Main switch
EN