Greenlee LDD-144 Manuel D'instructions page 11

Operation—Power Tool (cont'd)
Forward
Switch lock
Forward Rotation Switch Operation
1. Push the switch for forward (clockwise) rotation.
2. Depress the trigger slightly to start the tool slowly.
3. The speed increases with the amount of depres-
sion of the trigger for efficient tightening of
screws and drilling. The brake operates and the
chuck stops immediately when the trigger is
released.
4. After use, set the switch to its center position
(switch lock).
Reverse Rotation Switch Operation
1. Push the switch for reverse (counterclockwise)
rotation. Check the direction of rotation before
use.
2. Depress the trigger slightly to start the tool slowly.
3. After use, set the switch to its center position
(switch lock).
Switch Lock Operation
Push the switch to its centered position to lock the
tool. In the switch lock position, the trigger will not be
able to be depressed and the tool will not be allowed
to operate.
Reverse
11
Clutch Torque Setting
Test the setting before actual operation.
Adjust the torque to one of the 18 clutch settings for
driving fasteners or the drill setting
making operations.
The lower clutch settings deliver less torque than the
higher clutch settings. During operation a ratcheting
sound may be heard; release the trigger. This sound
indicates that the clutch is slipping because the driving
operation has overcome the available torque for the
engaged clutch setting.
For operations that require higher torque, use the low
speed setting.
Set the scale at this mark (
Speed Selection
• Check the speed selector switch before use.
• Use at low speed when high torque is needed
during operation. (Using at high speed when
high torque is required may cause a motor
breakdown.)
• Do not operate the speed selector switch (LOW-
HIGH) while pulling on the speed control trigger.
This can cause the rechargeable battery to wear
quickly or damage the internal mechanism of the
motor.
LDD-144
for hole-
)