Bissell POWERTRAK POWERFORCE 31L9 Serie Guide De L'utilisateur page 8

A
ssembly
1.
Connect the hose to the vacuum by inserting
the hose connector into the suction opening
on the bottom front of the vacuum. Push in
until it clicks into the locked position.
2.
Connect the telescoping extension wand to
the handle end of the hose.
3.
Connect the powerhead onto the telescoping
extension wand
4.
To extend the telescoping extension wand,
push the black release button and then pull
the bottom of the wand to the desired length.
5.
Once assembled you can store your vacuum
by inserting the wand storage holder into the
slot at the rear of the vacuum.
6.
Place the wand with the powerfoot into this
holder inserting the storage clip (located on
the back of the powerfoot) into the storage
holder. The wand storage holder can be left
in place on the vacuum during use or remove
during use if preferred.
NOTE: Shorten the length of the
telescoping extension wand for
storage.
6
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
WARNING:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies and
children.
1.
6.
8 0 0 . 2 6 3 . 2 5 3 5
1 - 8 0 0 . 2 6 3 . 2 5 3 5
Wand
Storage
Holder
5