Publicité
Les langues disponibles
Les langues disponibles
M
aintenance and care
Cleaning the Post-motor HEPA Media Filter*
The post-motor HEPA media filter* assists in the
filtration process to return clean air to the room. Use
only BISSELL replacement filters.
1.
Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2.
The post-motor filter is located behind the
door labeled "FILTER" on the rear of the
vacuum. Open the door by pushing down
on the tab of the door and pulling out to
remove.
3.
Remove the post-motor HEPA media filter*
by grasping the handle on the filter and
pulling out to remove.
4.
Replace the post-motor HEPA media filter*
with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter*.
This filter is NOT washable. To clean
gently tap to remove loose dirt and
debris or replace when dirty.
5.
Replace the filter door by inserting the two
tabs at the bottom of the filter door. Then
push down on the tab on the door and push
it back into the vacuum. Release the tab on
the door to lock into place.
Thermal protector
An internal thermal protector has been designed
into your vacuum to protect it from overheating.
When the thermal protector activates, the vacuum
motor will stop operating. If this happens:
1.
Turn the cleaner OFF (
electrical outlet.
2.
Empty dirt container, check filters and air
passages for dirt accumulation.
3.
Leave vacuum unplugged. The thermal
protector automatically resets after
approximately 2 hours then plug vacuum in
and turn ON (
does not reset, call BISSELL Consumer Care
or visit the website.
* The filter media, not the vacuum as a whole, complies with the
IEST-RP-CC001.5 or the EN-1822-1:2009 HEPA Standard.
12
w w w . b i s s e l l . c a
w w w . b i s s e l l . c a
) and unplug from
). If the thermal protector
3.
4.
1 - 8 0 0 . 2 6 3 . 2 5 3 5
Post-Motor HEPA
MediaFilter*
13
8 0 0 . 2 6 3 . 2 5 3 5
Publicité
