Blackstone Adventure Ready 2341 Manuel Du Propriétaire page 5

Model: 2341
Griddle body (1 piece)
1
Side shelf Hood handle
4 5
(1 piece) and 2-across screws
(1 piece)
ASSeMBlY INSTRUCTIoNS
TOOLS NEEDED: TOOLS NEEDED:
#3 Phillips head screwdriver & #3 Phillips head screwdriver &
Find a large, clean area to assemble your appliance�
Adjustable wrench Adjustable wrench
Remove all packing material before assembling�
Sharp edges. Wear gloves while assembling.
NOT INCLUDED: NOT INCLUDED:
lPG cylinder lPG cylinder
Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
lPG cylinder must include collar to lPG cylinder must include collar to lPG cylinder must include collar to lPG cylinder must include collar to
protect lPG cylinder valve. protect lPG cylinder valve. protect lPG cylinder valve. protect lPG cylinder valve.
Place griddle on its back� Screw the four (4) griddle feet into
STEP 01
the bottom of the griddle�
ensure that the fuel nozzle is housed within the burner opening�
NOT INCLUDED: NOT INCLUDED:
17" griddle base 17" griddle base
BLACKSTONEPRODUCTS.COM/SUPPORT
Griddle top and hood (1 piece)
2
Griddle feet
6
(4 pieces)
TOOL NEEDED: TOOL NEEDED:
#3 Phillips head screwdriver #3 Phillips head screwdriver
CAUTIoN
NOT INCLUDED: NOT INCLUDED: TOOLS NEEDED:
lPG cylinder lPG cylinder #3 Phillips head screwdriver &
Adjustable wrench
Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
NOT INCLUDED: NOT INCLUDED: NOT INCLUDED:
22" griddle base 22" griddle base lPG cylinder
Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
lPG cylinder must include collar to lPG cylinder must include collar to
protect lPG cylinder valve. protect lPG cylinder valve.
Griddle stand (1 piece)
3
CLEANING THE BURNER ASSEMBLY
To reduce chance of "flash-back" the procedure below should be
Grease cup and Propane regu-
7 8
followed at least once a month when spiders are most active or
liner (1 piece) lator (1 piece)
when your appliance has not been used for a period of time�
VIDEO TUTORIAL
How to Clean Your Burner Tube
youtube.com/watch?v=xKQTCrFCzf8
ensure that the gas is turned oFF at control knobs and gas
STEP 01
TOOL NEEDED: TOOL NEEDED:
supply� Remove the griddle top�
Adjustable wrench Adjustable wrench
Carefully detach and
STEP 02
remove the burner�
Heavy pieces. Two people should assemble this appliance.
Clean the inside of
STEP 03
the burner:
a. Run a bottle brush (not a wire
brush) or a stiff wire bent into
a small hook through each
burner tube several times�
b. Use compressed air to blow
through the burner tube and
out the burner ports (Wear eye
protection)�
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc) or rechargeable Brush entire
STEP 04
NOT INCLUDED: NOT INCLUDED: TOOL NEEDED:
outer surface of burner to
(ni-cad, ni-mh, etc.) batteries.
AA battery #3 Phillips head screwdriver AA battery
remove grime�
Clean any blocked ports
STEP 05
with stiff wire such as an open
paper clip�
Hot appliance. The cover MUST be open when the burner is in
Carefully replace
STEP 06
operation.
burners and reattach, with
attention to the location of the
ignition needle�
NOT INCLUDED:
lPG cylinder
Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
ASSEMBLY GUIDE | OWNER'S MANUAL
Bulk tank
9
adapter hose (1 piece)
TOOL NEEDED: TOOL NEEDED:
5mm Allen wrench 5mm Allen wrench
CAUTIoN
NOTICE
NOT INCLUDED: NOT INCLUDED: TOOL NEEDED:
one (1) AA battery (for ignition) one (1) AA battery (for ignition) Adjustable wrench
optional four (4) AA batteries optional four (4) AA batteries
(for the motor) (for the motor)
ELECTRIC REQUIREMENTS:
CAUTIoN
120V 60Hz
Fuel nozzle Fuel nozzle
Burner opening Burner opening
The gas rail fuel nozzle
must be reengaged within the
burner opening�
NOT INCLUDED:
AA battery
Pl
su
DO
co
TOO
5mm
DO
NOT
one
opti
(for
05