Tools Required For Assembly - SpeedEPart Agri-Fab 45-0315 Notice D'utilisation

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2) 7/16" Wrenches
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify
using the illustrations on page 3.
1. Assemble vinyl caps onto the ends of the R.H. and
L.H. Hitch Tubes. See figure 1.
2. Assemble the R.H. Hitch Tube to the spreader frame
tube using two 1/4" x 2-1/4" hex bolts and 1/4" hex
nuts. Do not tighten yet. Repeat for L.H. Hitch
Tube. See figure 1.
VINYL CAP
FIGURE 1
3. Assemble the Hitch Control Tube between the Hitch
Tubes using two 1/4" x 1-3/4" hex bolts and 1/4" hex
nuts. Tighten all bolts and nuts . See figure 2.
FIGURE 2
1/4" HEX NUT
1/4" x 2-1/4"
HEX BOLT
1/4" HEX NUT
1/4" x 1-3/4"
HEX BOLT
4. Assemble the Hitch Brackets to the Hitch Control
Tube using two 1/4" x 1-3/4" hex bolts and 1/4" hex
nuts. Tighten. See figure 3.
5. Assemble the hitch pin through the hitch brackets
and secure with the 1/8" hair cotter pin. See figure 3.
FIGURE 3
6. Assemble the vinyl cap onto the Hitch Control Tube.
See figure 4.
7. Assemble the Control Cable to the Hitch Control
Tube using the 1/4" x 2-1/4" carriage bolt and nylon
wing nut. See figure 4.
FIGURE 4
4
HITCH PIN
1/4" x 1-3/4"
HEX BOLT
1/4" HEX NUT
HAIR COTTER PIN
NYLON
WING NUT
VINYL CAP
1/4" x 2-1/4"
CARRIAGE BOLT