Télécharger Imprimer la page

ROMMER VCH460BUT Instructions D'utilisation Et D'installation page 43

Publicité

Les langues disponibles

Les langues disponibles

3. INSTALLATION AND PREPARATIONS FOR USE
Spanner
Injector
Figure 10
Figure 9
Oven/Grill Injectors:
The oven and grill injectors are assembled by a single screw that is placed on the tip of the burner.
For grill burners, this screw is already visible(Figure 11). Remove the screw, pull the grill burner to
yourself and you will see the injector revealed on the rear surface of the oven cavity (Figure 12).
For oven burners, open the drawer compartment and you will see the assembly screw below the
burner (Figure 13). Remove the screw, move the burner diagonally and the injector will be revealed on
the rear side of the burner box (Figure 12).
Remove the injectors with a 7mm spanner and replace the injector with the ones from the spare
set, with corresponding diameters suitable to the type of gas that is going to be used, according to
the information chart (which is also supplied in the gas conversion kit).
Screw
Screw
Injector
Figure 11
Figure 13
Figure 12
Adjusting the reduced flame position:
The flame length in the minimum position is adjusted with a flat screw located on the valve. For
valves with flame failure device, the screw is located on the side of the valve spindle(Figure 14). For
valves without flame failure device, the screw is located inside the valve spindle(Figure 15). For
easier reduced flame adjustment, it is advised to remove the control panel (and microswitch, if
present) during adjustment.
12

Publicité

loading

Ce manuel est également adapté pour:

Vch460natVch-450butVch-450gn