Drilling With The Machine - BDS Maschinen MAB 100 Mode D'emploi

Operation

Drilling with the machine

Drilling with core drills
40
Proceed as follows when drilling with core drills:
Insert the ejector pin (B) into the drill chuck.
‹
Insert the drill chuck with the ejector pin as described in
‹
chapter Inserting the tool.
Position the machine at the working location, align it and
‹
switch on the magnetic clamps.
Switch the machine on.
‹
Direct the drill with the hand lever (8) to the material.
‹
NOTE
Observe the following instructions when drilling with core drills:
► Drilling with core drills requires no great effort. The drill-
ing process is not accelerated by higher pressure. The drill
wears faster and the machine can be overloaded.
► Use the cooling lubricant system installed on the machine
with high-performance cutting oil BDS 5000.
► The cooling lubricant system cannot be used when working
overhead. In this case use the high-performance grease
spray ZHS 400. Spray the drill on the inside and outside
before drilling. Repeat this procedure when drilling deeper
holes.
► Pay attention to a regular chip discharge. With larger drilling
depths, break the chip.
MAB 100