ZANKER KEV6040FBB Notice D'utilisation page 13

For your safety, do not clean the appliance with steam
cleaners or high-pressure cleaners.
Scratches or dark stains on the glass-ceramic
cause no effect on how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted plastic, plastic
foil, and food with sugar. If not, the dirt can
cause damage to the appliance. Use a special
scraper for the glass . Put the scraper on the
glass surface at an acute angle and move the
blade on the surface .
Troubleshooting
Problem
You cannot activate the appliance
or operate it.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Installation
Warning! Refer to the Safety chapters.
Before the installation, note down the serial
number (Ser. Nr.) from the rating plate.The rating
plate of the appliance is on its lower casing.
KEV6040FBB
220-240 V 50-60 Hz
58 CAD 02 ZO
ZANKER
Built-in appliances
• Only use the built-in appliances after you assemble
the appliance into correct built-in units and work sur-
faces that align to the standards.
2.
3.
Possible cause
Problem with the house electrical
system.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
Connection cable
• Use the correct mains cable of type H05BB-F Tmax
• Replace the damaged mains cable with a special ca-
949 594 299 00
6 kW
– Remove after the appliance is sufficiently
cool: limescale rings , water rings, fat stains,
shiny metallic discolorations. Use a special
cleaning agent for glass ceramic or stainless
steel.
Clean the appliance with a moist cloth and some
detergent.
At the end rub the appliance dry with a clean
cloth.
Activate the appliance again and
set the heat setting in less than 10
seconds.
Examine the fuse in the electrical
system of the house in the fuse
box. If the fuses blow again and
again, speak to qualified electrician.
90°C (or higher) for a single phase or two phase
connection.
ble (type H05BB-F Tmax 90°C or higher). Speak to
your local Service Centre.
Remedy
13