Atag DW7214OMB/A02 Notice D'utilisation page 181

Troubleshooting
Error messages
F10 Overfilling water 1
F11 Water outlet fault
F12 Water inlet fault 1
F40 Inlet valve leakage
F41 Heater fault 1
F45 Diverter fault
F52 Water level fault
F54 Overfilling water 2
F56 Circulation pump fault
F67 Water inlet fault 2
F68 BLDC drain pump fault
Press any button to clear the error message.
Problem
The control panel does not react
when pressed.
30
Action
Unblocking the drainage pump. See the chapter Care and
cleaning. If the problem persists, contact your nearest service
centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Contact your nearest service centre.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, contact your
nearest service centre.
Turn off the water tap and contact your nearest service centre.
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest service centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Contact your nearest service centre.
Possible causes
You have pressed the control
panel too soon after opening the
door.
Child lock or Automatic child
lock is activated.
The door is closed.
Dirt on the control panel.
Action
Wait a moment then try again.
See the chapter Safety
instructions.
Open the door. The control
panel only reacts to use when
the door is open.
Clean with a dry or slightly damp
cloth.