Publicité
Les langues disponibles
Les langues disponibles
Cool Mode: The cooling function allows the air
conditioner to cool the room and at the same time
reduces air
humidity
activate the cooling function. To optimize the
function of the air conditioner, adjust the
temperature and the speed by pressing the button
indicated.
Dry Mode: This function reduces the humidity of
the air to make the room more comfortable. Press
the MODE button to set the DRY mode. An
automatic function of alternating cooling cycles
and air fan is activated.
Fan Mode: This function only works when the air
conditioner is vented. Press the MODE button to
set the FAN mode. With pressing the FAN SPEED
button, the speed changes in the following
sequence: Hi, Med and Lo in FAN mode.
Auto Mode: In AUTO mode the unit automatically
chooses the mode of operation (COOL,DRY or
FAN).In this mode the temperature will be set
according to the room temperature (tested by the
temperature sensor which is incorporated in the
indoor unit.).
5. Timer Button:
Use these buttons on the control
panel and remote to set the Timer.
Timer Off: The timed stop is programmed by
pressing TIMER button. Set the rest time by
pressing the button
time displayed is to your
button again.
Timer On: When the unit is off, press TIMER
button , set the temperature with
pressing the button
button
a second time
pressing the button
button
, confirm the setting, then
a third time
automatically switch on and will show on the display.
Note: It can be set to automatically turn off or on in
0.5-24
hour increments
buttons will increase or decrease the timer.
The Timer can be set in 0.5 hours increment below
10 hours and 1 hour increment for 10 hours or
above.
The SET light will turn on while setting.
To cancel the
function, press the TIMER button
set
again.
. Press the MODE button to
or
until the rest
then press TIMER
liking
or
. Press TIMER
, set the rest time with
or
. Press TIMER
. Each press of the
6. Eco Button:
light will turn on. In ECO mode, the unit will
turn off once the room is cooled to the user set
temperature. Fan will also be off at this point.
The unit will turn back on when the room
temperature rises above the user set temperature.
Before the compressor
run for a while, then it will stop for a while, and will
repeat to provide a much more comfortable feeling
and save energy.
7. Sleep Button:
display lights will turn off after a while, but the
Sleep light is always on. In SLEEP mode, the air
conditioner will automatically adjust the
temperature and fan speed to make the room
more comfortable during the night. The set
temperature will automatically raise every 30-60
minutes, and at most change six times until the
set temperature is 81 or 82 .
8. Fan Speed Button:
to choose the fan speed options. You can choose
Hi, Med, Lo or auto speed in COOL mode
choose Hi, Med, Lo in FAN mode.
9.
Filter Button:
it is
not necessary
When the Filter Check light is on,
the light by pressing the Filter Check button. After
the fan motor works for 500 total hours, the Filter
Check light will turn on to remind the user to clean
the filter.
will
10.
Directional Louvers:
horizontal wheel to control the horizontal direction
and use the air deflectors to control the vertical
direction.
air deflector
13
When the unit is in ECO mode, the
starts
,
the fan motor will
Press the SLEEP button, all of the
Press the FAN SPEED button
When the Filter Check light is off,
to press the Filter Check button.
you
To direct the airflow, use the
horizontal wheel
or
can turn off
air deflector
Publicité
