VOLTOMAT HEATING FH-110705.1 Mode D'emploi page 80

FH-110705.1 / FH-110705.2
PARTS DESCRIPTION
1. Thermostat control switch
2. Air outlet grille
3. Heat select switch
4. Handle
Heat setting:
"0" position – OFF
– Ventilation
– WARM AIR (low heat output)
– WARM AIR (high heat output)
THERMOSTAT
1. Rotate the switch to choose the suitable setting --- ventilation/ WARM AIR (low heat output)/ WARM
AIR (high heat output).
2. Turn the thermostat knob in a clockwise direction to the max position.
3. Once the room temperature has reached the desired value, turn the thermostat knob slowly in
anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
4. The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting, and switch off if it is above the setting.
Note: To switch off the appliance, it is recommended to turn the heat switch to ventilation setting for about
15 seconds to cool down. After that, please turn the heat switch to "0" position and then unplug the
appliance. This can help prolong the lifespan of the appliance.
SAFETY SYSTEM
The appliance has a safety system which automatically switches the unit off when overheated.

If overheating occurs, switch off the appliance, remove the plug from the socket, and let it cool down

for at least 10 minutes. Put the plug in the socket and switch the heater on.
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will

automatically switch off the power if it is put on unstable or uneven surfaces or if it is tilted
accidentally.
MAINTENANCE
The fan heater only needs regular cleaning on the outside.

Before you clean the unit, turn the switch off. Remove the plug form the socket and wait until the fan

heater cools down completely.
Use a damp cloth to wipe the heater housing.

Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the

appliance.
- 79 -
GB