Troubleshooting Guide - XPower A-2 Manuel D'emploi

Troubleshooting Guide

PROBLEM
Electric duster
does not start
Unit runs but
the speed is
abnormal
Noise
Abnormal
Temperature
of the airflow
or housing
Sparks
Nozzle falls off The nozzle is not properly
(See Page 3: Special Instructions)
If troubleshooting does not resolve your problem, please contact XPOWER or other parties
authorized by XPOWER for further instructions.
English - 12
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
Air inlet or air outlet is blocked.
This product uses a high RPM
motor to provide powerful airflow
and could create a certain level of
noise. This is a normal sound.
Air inlet or air outlet is blocked
This product generates powerful
motor heated air. After a
prolonged use, the airflow and
the machine surface might reach
a high temperature.
Occasion small amount of sparks
generated by the motor during
normal operation.
Unit works with continuous
sparks.
installed.
SOLUTION
Check for power supply.
Remove and reconnect the power
cord.
Remove blockage and clean the
filter or nozzle attachment.
Use a wider opening nozzle
attachment, switch to the lower
speed setting or operate in a
outdoor place.
Remove blockage and clean the
filter or nozzle attachment.
Stop using for at least one hour
until fully cooled down. Clean the
filter and check if the air inlet or
outlet is blocked. Use a glove the
isolate the heat coming from the
housing.
This is normal. Use nozzle
attachments to arrest most of the
occasion sparks along use.
Stop using for at least one hour
until the unit cools down. Clean
the filter and check if the air inlet
or outlet is blocked. Then point
to a safe area and turn on the
machine for 5 minutes. Spark
should disappear.
Follow the installation guide.
Fasten the nozzle before use.