LEXIBOOK JG7430 02 Mode D'emploi page 15

Console:
Adapter:
1. Make sure the game console is switched off.
2. Connect the adapter plug (supplied) to the socket 6 located on the back side of the console.
3. Connect the adapter into a main socket.
4. Switch the game console on 2 .
Warning: Disconnect the adapter if the game is not used for a long period of time to prevent overheat-
ing. When the game is powered by an adapter, do not play outside. Check the state of the adapter and
the connection cords regularly. If their condition is deteriorating, do not use the adapter until it has been
repaired. The toy shall only be used with a transformer for toys. The adapter is not a toy. The console
should be disconnected from the power supply to be cleaned if liquids are used for cleaning. The toy is
not intended for children under 3 years old. Misuse of transformer can cause electrical shock.
Wireless controllers:
1. Use a screwdriver to open the battery compartment located at the back of the controller.
2. Install the 2 x LR03/AAA type batteries observing carefully the polarity indicated at the bottom of the
battery compartment and as per the diagram shown below .
3. Close the battery compartment and tighten the screw.
4. Repeat the 3 previous steps to install the batteries of the second controller.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy
before being charged. Rechargeable batteries are only to be charged under adult supervision. Different types
of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as
recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are
to be removed from the toy. The supply terminals are not to be short circuited. Do not throw batteries into a
fire. Remove the batteries if you are not going to use the game for a long period of time. Battery shall not be
exposed to excessive heat such as sunshine, fire or the like.
The toy is only to be connected to Class II
equipment bearing the following symbol.
WARNING: Mal-function or loss of memory may be caused by strong frequency interference or electrostatic
discharge. Should any abnormal function occur, reset the unit or remove the batteries and insert them again, or
unplug the adapter from the mains socket and plug it back in.
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
Before using the unit, be sure to read all operating instructions carefully. Please note that these are
general precautions and may not pertain to your unit
1. Read this Instruction Manual before you attempt to connect or operate the appliance.
2. Keep these instructions in good condition. Heed all warnings. Follow all instructions.
3. Save this Instruction Manual for future reference.
4. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such
as vases, shall be placed on the product. Dry location use only.
5. No naked flame source, such as candles, should be placed on the product.
JG7430_02IM2480_327_V03.indb 15
Safety Instructions
15
27/11/2020 2:30 PM