2N EasyGate IP Mode D'emploi page 3

Mechanical Installation
2N® EasyGate IP is designed for indoor mounting on a vertical surface using a DIN rail bracket (35 mm) or a wall bracket using
screws fitted to the bracket mounting holes. The installed device is intended for continuous operation at a minimum distance of
20 cm from the user.
Wall Mounting
Use the bracket and two dowels with screws included in the package to install 2N® EasyGate IP on a wall. Drill holes in a selected
place and selected height of the wall and insert the dowels. Pass the screws through the bracket holes and screw them into the
dowels in the wall. Now all you have to do is slide 2N® EasyGate IP from the top into the DIN rail bracket profile and fit its position
with a screw.
DIN Rail Mounting
No other tool is needed for DIN rail installation. Put the upper inner side of the bracket profile on the DIN rail and push its bottom
side to make the bracket click and fit to the DIN rail. Now all you have to do is slide
2N® EasyGate IP from the top into the DIN rail bracket profile (A) and fit its position with a screw (B).
!
!!! Only vertical mounting with the connectors heading down guarantees that the device is waterproof.
If installed otherwise, the device may be infiltrated with water and damaged irreversibly !!!
The device may be operated in a temperature range of 0 °C – 45 °C if equipped with the provided batteries, or at
temperatures outside this range without these batteries. Make sure that batteries with increased thermal resistance
are used to preserve the backup function. You can connect an external battery with increased thermal resistance or
place the external battery to a place with a convenient temperature.
Putting in Operation
1. SIM Card Installation
Insert a SIM card (Mini SIM size) into one of the SIM slots on the device bottom side. Remember to set provider services such as
call forwarding, call barring, preferred networks, SMS centre, etc. in your mobile phone, for example, before inserting the SIM card
in 2N® EasyGate IP.
2. Antenna Connection
Screw the enclosed antenna into the SMA antenna connector. Tighten the antenna connector gently with your hand, never use a
wrench!
3. Device Connection to Power
Connect the included power supply terminal block into the dedicated Power connector and connect the power supply to the
electrical mains.
We recommend that the Panasonic HHR-210AAB batteries included in the factory product delivery are used for supply backup.
Use 2N® Elevator Center, a licensed cloud service, for 2N® EasyGate IP remote management. Contact your distributor for the
service access data. Refer to 2n.com for more details on 2N® Elevator Center.
To configure 2N® EasyGate IP without the 2N® Elevator Center cloud service, connect the device to a PC via a USB cable using the
2N® EasyGate IP – Web configuration utility available for free download at 2n.com.
The 2N® EasyGate IP local connection tool also includes a manual, which describes the tool installation and guides the user as far
as the web interface login page. For the first login, enter Admin as the username and 2n as the password. You will be prompted to
change the default password upon the web interface login.
Refer to the full 2N® EasyGate IP User Manual at wiki.2n.com for configuration details.
19
2