Surface Temperatures
When the range is in use, all range surfaces may become hot,
such as the knobs and oven door.
Storage Drawer
When the oven is in use, the drawer may become hot. Do not
store plastics, cloth, or other items that could melt or burn in
the drawer.
Oven Vent
The oven vent releases hot air and moisture from the oven and
should not be blocked or covered. Do not set plastics, paper,
or other items that could melt or burn near the oven vent.
Preheating
When beginning a Bake, Convect Bake, or Convect Roast
cycle, the oven will begin preheating after Start is pressed.
The oven will take approximately 12 to 15 minutes to reach
350°F (177°C) with all of the oven racks provided with your
oven inside the oven cavity. Higher temperatures will take
longer to preheat. The preheat cycle rapidly increases the
oven temperature. The actual oven temperature will go above
your set temperature to offset the heat lost when your oven
door is opened to insert food. This ensures that when you
place your food in the oven, the oven will begin at the proper
temperature. Insert your food when the preheat tone sounds.
Do not open the door during preheat before the tone sounds.
Ceramic Glass Cooktop Cleaning
To avoid damaging the cooktop, do not use steel wool,
abrasive powder cleansers, chlorine bleach, rust remover,
or ammonia.
1. Remove food/residue with a cooktop scraper.
6
KEY USAGE TIPS
■
■
Allow the cooktop to cool down completely before
proceeding to Step 2.
2. Apply a few dime-sized drops of a cooktop cleaner to the
affected areas.
■
■
3. Polish with a clean, dry cloth or a clean, dry paper towel.
■
The Complete Cooktop Cleaner Kit (part number 31605) is
available for order from sears.com (see the back cover of this
Use and Care Guide for additional contact information) and
includes the following:
Cooktop scraper
■
Cooktop cleaner
■
Blue cooktop cleaning pads
■
For best results, use the cooktop scraper while the
cooktop is still warm but not hot to the touch. It is
recommended to wear an oven mitt while scraping
the warm cooktop.
Hold the cooktop scraper at approximately a 45°
angle against the glass surface and scrape the residue.
It will be necessary to apply pressure in order to
remove the residue.
Rub the cooktop cleaner onto the cooktop surface with
a cooktop cleaning pad. Some pressure is needed to
remove stubborn stains.
Allow the cleaner to dry to a white haze before
proceeding to Step 3.
Repeat steps 1 through 3 as necessary for stubborn
or burned-on stains.