Hisense RF750N4ISF Livret D'instructions page 43

13
The initial dark discoloration of water is
normal.
The water lines must be connected
with the potable water only.
To operate properly, the ice maker
requires a water pressure of 207~689
Kpa.
Connect filter outlet line to the fridge
The outlet line of the water filter should be
connected with the inlet line of the
refrigerator by a Two-Way Connector.
The water lines must be fully inserted into
the center of the connector to prevent
water leaking.
Insert the 2 clips in the install pack as
shown in the diagram, and then confirm
that each clip holds the line firmly.
Open the water valve to flush the lines,
and check leakage in the water
connectors. If any leak, please check that
if the lines are fully inserted where the
connector leaked. If not, please install
them again, and make sure that the lines
are fully inserted.
Note:
After connect the filter outlet line with the
refrigerator(as shown in the diagram
below), please dispense several cups of
water to flush the lines before use.
The water lines should not be pressed by
heavy things and should not bend too
much.
Warning!
After turning on the water valve, make
sure that there is no leakage at all
connection points of the water lines. If
there is a leakage, turn off the valve
immediately and
connector or make the lines fully inserted
into the connector.
Do not pull the water lines hard, it may
damage the water system.
tighten the water