Blackstone PRO Serie Manuel Du Propriétaire page 10

Owner's Manual |
! !
WA r n I n G WA r n I n G
The manufacturer has made The manufacturer has made
every effort to eliminate any every effort to eliminate any
sharp edges. However, you sharp edges. However, you
should handle all compo- should handle all compo-
nents with care to avoid nents with care to avoid
accidental injury. accidental injury.
Some parts may contain Some parts may contain
sharp edges, especially sharp edges, especially
as noted in these instruc- as noted in these instruc-
tions. Wear protective tions. Wear protective
gloves if necessary. gloves if necessary.
Troubleshooting
! !
WA r n I n G WA r n I n G
The use of alcohol, prescrip- The use of alcohol, prescrip-
tion or non-prescription tion or non-prescription
drugs may impair the drugs may impair the
consumer's ability to prop- consumer's ability to prop-
erly assemble or safely erly assemble or safely
operate the appliance. operate the appliance.
!
C A U T I o n
Two people are recom-
mended for the assembly
of this product.
dle
r.)
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
nega-
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
osi-
rner
06
e.
Assembly Guide
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
Please read all instructions thoroughly before proceeding. Make sure all Please read all instructions thoroughly before proceeding. Make sure all
the plastic packing material is removed before assembling. the plastic packing material is removed before assembling.
Find a large, clean area to assemble your unit. Please refer to the parts list and Find a large, clean area to assemble your unit. Please refer to the parts list and
assembly diagrams as necessary. assembly diagrams as necessary.
S T E P 0 1
from the packaging and lay it upside down on a smooth, flat surface.
Install the two (2) control knobs by pushing them into place in the OFF posi-
tion. Insert one (1) AA battery (not included) under the ignition button.
S T E P 0 2
bolts and nuts from the two (2) fixed
wheels to attach them to the right
leg assembly.
Use a wrench to attach the two
(2) caster wheels to the left leg
assembly.
With the help of another person, remove the griddle body
Use the pre-installed
Model 1858
Push to lock