Dyna-Glo DGPH401BR Manuel Du Propriétaire page 8

ASSEMBLY INSTRUCTIONS
3. Insert the pins on the three corners of the
bottom plate (R) into the corresponding
holes on the lower section of the three lower
supports (K). Press the bottom plate (R)
down to secure.
Note before assembling the control box
assembly (I): The control knob (P) on
the control box assembly (I) should be
positioned on the same side as the front
panel "insert holes" on the bottom plate (R).
Insert the pins on the three corners of
the control box assembly (I) into the
corresponding holes on the upper section
of the three lower supports (K). Press the
control box assembly (I) down to secure.
4. Insert the three upper supports (G) into the
lower supports (K) as illustrated.
3
I
P
K
R
4
G
K
8
PIN
FRONT PANEL
INSERT HOLE
PIN