Publicité
Les langues disponibles
Les langues disponibles
OPERATION INSTRUCTIONS
4. Push the electric ignitor button until pilot flame is visible through the glass tube.
5. Once the pilot is lit, continue to depress the control knob for 30 seconds.
6. If the pilot does not stay lit, repeat steps 3 to 5.
7. If after repeating steps 3 to 5 unit does not light, then
-Push in control knob and turn counterclockwise to "PILOT" ( ) (Figure 2).
-As you are depressing the control knob, attach match (not included) to the long stem lighter assembly
(MM) and place it through the hole on the control panel to light the pilot (Figure 3).
-Repeat step 5.
Figure 2
8. Push in and turn the control knob to the "HIGH" (
control knob. If you want a lower temperature, push in the control knob
and turn counterclockwise to "LOW" ( ) (Figure 4).
Note: If pilot fails to remain lit, all valves should be closed and a waiting
period of at least 5 minutes should pass before attempting to light.
If you experience any ignition problem please consult "Troubleshooting" on page 22.
Caution: Avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning of oils
used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The
heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner,
turn the control knob to the PILOT position. Then, turn the knob to the level of heat desired.
Figure 3
), then release
18
Figure 4
Publicité
