Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
13. Note: Do not cover the front side where
the control knob is located.
Attach the two side panels (L) to the
lower supports (K) using eight M5 x 12
mm screws (EE). Tighten with the Phillips
screwdriver (OO).
Hardware Used
M5 x 12 mm Screw
EE
Phillips
OO
screwdriver
14. Install the knob (KK) and the chain and
long stem lighter assembly (MM) using one
M4 x 6 screw (LL) as illustrated in figure
14A.
Insert the hooks at the bottom of the front
panel (S) into the corresponding holes at
the bottom plate (R) as illustrated.
Take the hook at the other end of the chain
and long stem lighter assembly (MM) and
attach it to the hole next to the magnet on
the control box assembly (I) as illustrated in
figure 14B. Close the front panel (S).
Hardware Used
Knob
KK
Screw M4 x 6
LL
Chain and
MM
Long Stem
Lighter Assembly
Phillips
OO
screwdriver
13
x 8
EE
14
Figure 14A
x 1
KK
x 1
x 1
13
L
Figure 14B
S
LL
MM
K
I
R
Publicité
