Dyna-Glo DGPH401BR Manuel Du Propriétaire page 12

ASSEMBLY INSTRUCTIONS
11. Put the flame screen (B) over the upper
plate (E). Make sure the holes on the side
of the flame screen (B) are aligned with the
holes on the upper plate (E).
Connect the fixing brackets (FF) to the
upper plate (E) and flame screen (B) with
three M5 x 12 mm screws (EE).
Make sure the fixing brackets (FF) are
securely fixed to the protective guards (O).
Then tighten the screws with the Phillips
screwdriver (OO).
Hardware Used
M5 x 12 mm Screw
EE
Fixing Brackets
FF
Phillips
OO
screwdriver
12. Assemble the reflector panel (A) onto the
flame screen (B).
WARNING: Be sure to remove the
protective film from the reflector panel
(A) before assembly.
Screw the three reflector spacers (CC) into
the pre-drilled holes in the flame screen
(B) and tighten with the wrench (GG).
Put three washers Φ8 (BB) onto the top
of the reflector spacers (CC). Then put
the reflector panel (A) onto the reflector
spacers (CC), securing them with three
washers Φ8 (BB) and three wing nuts (AA).
Hardware Used
Wing Nut
AA
Washer Φ8
BB
Reflector
CC
Space
Wrench
GG
11
EE
x 3
x 3
12
x 3
x 6
x 3
12
B
FF
O
A
B
E
AA
BB
CC