• Keep the appliance and its cord out of reach of children less than
8 years.
• Do not repair the appliance by yourself. Always contact an au-
thorized technician. If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
CAUTION:
This appliance is not intended to be immersed in water during
cleaning. Please observe the instructions that we have included
for you in the chapter "Cleaning".
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging materials like foils, filling materi-
als, cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.
4. If there are missing parts or obvious damage, do not use
the appliance. Return it to your retailer immediately.
Scope of Delivery
1 × Hot air fryer
1 × Frying basket with lid
1 × Removal tool
2 × Fixing discs for spits
1 × Rotisserie
1 × Baking tray / Grease drip tray
2 × Slide-in grid
Overview of the Components
Picture A, Page 3
1 Air inlet opening
2 Display
3 Air outlet opening
4 Housing
5 Door
6 Door handle
7 Release
8 Guide rail
9 Mount for the rotisserie / frying basket
10 Control panel
11 Frying basket
11a Lid
12 Removal tool
13 Fixing clips
FR6031HCB_IM
14 Rotisserie
15 Baking tray / Grease drip tray
16 Slide-in grid
Picture B, Page 4: Symbols on the Control Panel
17 Buttons for program selection
18
and
buttons for the time setting (
19
button (Switching the appliance on / off)
20
button (Add rotisserie)
21
button (Warm up food)
22
button (Turn on the lighting)
23
and
buttons for the temperature setting (
Notes for Use
Location
• Set the appliance onto a non-slip, level, and heat-resist-
ant surface.
• Take care that the appliance and the mains cable never
are placed onto hot surfaces or near heat sources (e. g.
range, hob).
Connected Wattage
The total power consumption of this appliance can be up
to 1500 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
)
)
43
24.10.19