VOSS.farming easyCUT go 85340 Mode D'emploi page 25

INSTRUCTION MANUAL VOSS.FARMING EASYCUT GO
7.5 CHANGING BLADES
A set of blades consists of an upper and a larger, lower blade whose ground sides
always lie on top of each other.
CAUTION
Keep your fingers away from the sharp edges of the blades to avoid injury.
1. Switch off the clipper and remove the battery from
the device (see section 7.4).
WARNING
Only carry out the following steps after ensuring
that the device has been switched off and the
battery removed.
2. To loosen the tension on the blades, turn the
tensioning nut (2).
The blades are now loose.
3. Turn the clipper over and place the clipper on a
flat, stable surface.
The fixing screws (7) are at the top.
4. Loosen the fixing screws (7) using the enclosed
wrench (Fig. 5).
NOTICE
Do not remove the fixing screws (7) completely.
You can remove the old blades.
5. Make sure that the new blades, especially the
grinding sides, are free of impurities.
6. Insert the upper blade into the guide points of the
oscillating head.
7. Oil the upper blade on the grinding surfaces with
the oil (Fig. 6).
8. Slide the lower blade between the loosened fixing
screws (7).
9. Position the lower blade so that it protrudes
approx. 1.5 to 2 mm beyond the upper blade
(Fig. 7).
10. Tighten the fixing screws (7) using the enclosed
wrench.
85340 | 02 | 2021 | V2
Fig. 5
Fig. 6
approx
1,5 to 2 mm
Fig. 7
DE
EN
EN
FR
IT
NL
SV
ES
PL
25