Publicité
INSTRUCTION
1.Place the sink upside down in the position where it is to be installed and trace the outline of the
sink on the bench top with a pencil.
2.Draw another line 10mm inside the first line, cut a hole in the bench top following this second
inner line.
3.Adhere the bench seal around the under side of the edge of the sink, being careful to lay it
smoothly(without ridges)
4.Place the anchor braces vertically and pull them up to lock into their horizontal position.
5.These anchor braces are designed for use with bench tops 35-45mm thick(1). If your counter
top is thinner, insert wooden wedges between the counter top and the braces so as to secure
them(2). After placing two at each comer of the sink, place the rest evenly spaced around the
perimeter of the sink.
6.Tighten the screws of the anchor braces (with a hand screwdriver),to secure the sink in place.
CARE INSTRUCTIONS
For everyday cleaning of the sink, use household detergents suitable for stainless steel.
After each use, rinse the sink with warm water then wipe with a soft dry cloth.
-Do not use steel wool to clean your sink.
-Do not use chemical "silver cleaners", bleaches, or detergents containing chlorine or any of its
derivatives.
WARNING!
-If the sink comes into contact with acidic materials, rinse immediately with plenty of water and
wipe with a soft, dry cloth.
-Do not leave rusty objects in contact with the sink. Rust can cause staining, cracking or even
permanent damage to the sink surface.
-To avoid staining of the surface do not leave food or other materials with corrosive properties
such as juices, salt, vinegar, mustard etc. on the sink for a long time.
-Do not place very hot objects directly on the sink. Place them on a special surface (board) made
from wood or plastic, etc.
-Avoid scraping the sink basin or draining board with utensils.
-Avoid dropping heavy or sharp objects onto the sink surface.
IMPORTED BY
AMC
123 quai Jules Guesde
94400 Vitry sur seine
France
LOT#: amc082018
7
Publicité
