Please troubleshoot using the details below before contacting Omega Customer
Service for repair or service. When contacting Omega for after-sales service, please
have the manufacturer's serial number or bar code available.
The Appliance Does Not Work
•
Make sure the power cord is plugged in correctly.
•
Make sure the drum is assembled correctly. If the drum is not locked into place, the
appliance will not operate.
•
Make sure the appliance is assembled according to the instructions in this manual.
Refer to the instructions.
•
If the appliance still does not work, please contact Omega Customer Service for
additional support.
The Drum Does Not Open
•
If there is a lot of pulp inside the drum, press [On] to release the excess pulp.
•
Check the appliance for any foreign substance or solid objects including seeds.
•
Press [Rev] button to push up stuck ingredients.
•
Do not attempt to open by force. If the drum still does not open, please contact
Omega Customer Service for additional support.
The Appliance Stops During Normal Operation
•
Check for large pieces of food stuck in the appliance.
•
Refer to the section "If the Auger Stops Working" and follow the guideline for the
[Rev] button.
•
If the appliance still does not work, please contact Omega Customer Service for
additional support.
Fine Lines or Scratch Marks around the Auger
•
This is normal. Do not be concerned. These are molding marks resulting from the
normal manufacturing process.
Juice Leaks Over the Base
•
Check for an excessive amount of ingredients in the hopper and/or chute.
•
If you try to juice a large amount of food compared to the pulp chute, the packing
will be slightly pushed away. Juice may leak out of the gap.
•
Do not force too much food into the juicer. Push food gradually for extraction.
•
Check to make sure the juice flap is closed.
Juicer Shakes when In-Use
•
This is normal as the auger rotates. It is not a malfunction. Hard ingredients such as
carrots, potato, radish, beets, etc. may cause shaking more so than soft ingredients.
•
Depending on the firmness of the ingredient, there may be a more pronounced
shaking of the motor.
•
Slight shaking may be caused by the motor.
TROUBLESHOOTING
14