Kenmore ELITE CALYPSO Guide D'utilisation Et D'entretien page 8

INSTALLATION
INSTRUCTIONS
Install the rear self-adjusting feet
1. To prevent floor damage, set the washer onto cardboard.
2. Move the washer to within approximately 3 feet (90 cm) of the
final location.
3. Prop up the rear of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
4. Install the self-adjusting rear feet by pushing all the way up
into the hole shown below.
5. Tilt the washer forward and remove the wood block. Gently
lower the washer to the floor.
Install the front leveling feet
6. Prop up the front of the washer about 4 in. (10.2 cm) with a
wood block or similar object. The block needs to support the
weight of the washer.
7. Screw the lock nut onto each foot to within 1 in. (2.5 cm) of
the base.
8. Screw the feet into the correct holes at the front corner of the
washer until the nuts touch the washer.
NOTE: Do not tighten the nuts until the washer is level.
9. Tilt the washer back and remove the wood block. Gently
lower the washer to the floor.
Proper connection of the drain hose protects your floors from
damage due to water leakage. Carefully read and follow these
instructions.
The drain hose is connected to your washer and is stored inside
of the washer cabinet.
Remove drain hose from washer cabinet
Gently pull the corrugated drain hose out of the washer from the
top of the hose. Continue to pull the hose until the end emerges.
Do not force excess drain hose back into the rear of the washer.
f
Laundry tub drain or standpipe drain
Connecting the drain hose "hook" to the corrugated drain
hose
1. Open the yellow single-wire clamp and slide over the end of
the drain hose about 4 in. (10.2 cm) (Pliers optional.)
2. Wet the outside end of the drain hose with tap water. Do not
use any other lubricant.
3. Twist and push the "hook" back and forth while pushing
down onto the drain hose. Continue until the "hook" is down
to the enlarged diameter of the drain hose.
4. Open the yellow single-wire clamp (placed on the drain hose
earlier) and slide over the base of the drain hose "hook" to
secure the sections together. (Pliers optional.)
5. Put hooked end of drain hose into laundry tub or standpipe.
Rotate "hook" to eliminate kinks.
To prevent drain water from going back into the washer:
• Do not straighten hooked end of the drain hose and force
excess drain hose into standpipe. Hose should be secure but
loose enough to provide a gap for air.
• Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose "hook" on to the corrugated drain
hose. You may need additional parts. (See Floor Drain under
"Alternate Parts You May Need.")
8