Kenmore ELITE CALYPSO Guide D'utilisation Et D'entretien page 16

next to MINIMUM illuminates. This is the shortest wash time
available for that cycle.
Modifiers allow you to further customize your cycles and save
energy.
Wash/Rinse Temp
Select a water temperature based on the type of load you are
washing. Use the warmest water safe for fabrics. Follow garment
label instructions.
l MA_MUM
o
o _RMAL
o
O MiNImUM
Warm rinses leave the loads dryer than cold rinses. Warm rinses
increase wrinkling. In cold climates, a warm rinse makes the load
more comfortable to handle. Cold rinses save energy. When a wash cycle is started, the estimated time remaining for
the cycle, including fills and drains, will be displayed. The time
Temperature Guide will count down to the end of the cycle. The ESTIMATED TIME
Wash Water Temperature Suggested Fabrics REMAINING light will glow.
HOT Whites and pastels
111°F (44°0) or above Heavy and greasy soils
O ESTIMATED _ME
P_MAINING
WARM Bright colors
90°-110°F (32°-43°0) Moderate to light soils
COLD Colors that bleed or fade
7O°-9O°F (21°-32°0) Light soils
In wash water temperatures colder than 70°F (21°C), detergents
do not dissolve well. Soils may be difficult to remove.
Auto Temp Control
ATC (Auto Temp Control) electronically senses and maintains a
uniform water temperature. ATC regulates incoming hot and cold
water. The ATC is automatically turned On when a cycle is
selected. (See "Preset
Cycle Settings" in "Cycles,")
ATC is available with WARM/WARM, WARM/COLD and COLD/
COLD settings,
The AUTO TEMP CONTROL light will glow
indicating that ATC is working.
o _TO TEMP
CONTROL
o HOT/COLD
o WARM / WAF_
o WARM / COLD
o COLD / COLD
o T_ COLD/OOLD
Set Delay Time
You can use the SET DELAY TIME feature to delay the start of a
wash cycle for up to 11 hours (depending on you model).
1. Load the washer and fill the dispensers.
2. Close the washer lid.
3. Select the desired Cycle, Options and Modifiers.
4. Press SET DELAY TIME. 1H (one hour) will be displayed in the
time display window. The indicator light for DELAY TIME will
glow.
OIl-LAY _ME
• ATC ensures consistent cleaning.
• When using ATC, warm water is added to the washer to
maintain a termperature of approximately 75°F (24°C), so
detergents dissolve properly.
• Warm washes are regulated at approximately 1O0°F (38°C).
• Warm rinses are regulated at approximately 75°F (24°C). This
is a cooler warm rinse than you are used to, but it saves
energy and gives proper rinsing. The load is a comfortable
temperature to remove from the washer
Wash Time
Wash Time is preset for each wash cycle. (See "Preset Cycle
Settings" in "Cycles.") As you press WASH TIME pad, the cycle
time (minutes) will increase or decrease in the ESTIMATED TIME
REMAINING display and a different WASH TIME light will glow. To
get the minimum wash time, press the pad until the indicator light
5.
6.
For a longer delay time, press SET DELAY TIME. The time will
increase by one-hour steps.
Press START. The countdown to the wash cycle will show in
the time display window.
To change the Delay Time:
• Press STOP/CANCEL.
• Reset the SET DELAY TIME.
• Press START to begin the countdown.
To cancel Delay Start:
Press START again to begin the cycle right away or press
STOP/CANCEL twice.
16