Télécharger Imprimer la page

Kenmore ELITE CALYPSO Guide D'utilisation Et D'entretien page 10

Publicité

Les langues disponibles

Les langues disponibles

Properly leveling your washer prevents excessive noise and
vibration.
1. Check the levelness of the washer by placing a level on the
top edge of the washer, first side-to-side,
then front-to-back.
1. Check the electrical requirements.
Be sure that you have the
correct electrical supply and the recommended
grounding
method. (See "Electrical Requirements.")
2. Check to be sure all parts are now installed. If there is an
extra part, go back through the steps to see which step was
skipped.
3. Check to be sure you have all of your tools.
4. Dispose/recycle
all packaging materials. Keep the styrofoam
for use if the washer should be transported.
5. Check to be sure the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, prop up the
front of the washer with the wood block and adjust the feet
up or down as necessary. Repeat this step until washer is
level.
2. After the washer is in the final location and level, use a
9/18 in. (1.43 cm) open-end wrench to turn the nuts on the feet
tightly against the washer cabinet.
If the nuts are not tight against the washer cabinet, the
washer may vibrate.
3. Tilt the washer forward until the rear of the washer is at least
4 in. (10.2 cm) off the floor. You may hear the self-adjusting
rear feet click into place. Lower the washer to the floor.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. Remove the protective film on the console and any tape
remaining on the washer.
9. Read "Washer Use."
10. To test your washer, measure _&the normal recommended
amount of powdered or liquid detergent and pour it into the
detergent dispenser. Close the lid. Press HEAVY DUTY, and
then press START. Allow it to complete one whole cycle.
10

Publicité

loading