Publicité
Les langues disponibles
Les langues disponibles
• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure 16).
• When the wound cutting line reaches
the recesses (x), cut the line. (figure 15).
• Fit the spool onto the tool as described
in "REPLACING THE SPOOL".
CAUTION:
Before you begin
trimming, only use the appropriate type of
cutting line.
MAINTENANCE
WARNING:
To avoid serious injury, switch off and unplug the
tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp
rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
16
TOOL RUNS SLOWLY
AUTOMATIC LINE FEED DOES NOT WORK
10
Get other manuals https://www.bkmanuals.com
TROUBLESHOOTING
• Check that the spool housing can rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not protrude more than
approximately 5-3/8 inches (136mm) from the spool. If it does, cut
it off so that it just reaches the line trimming blade.
• Keep the tabs depressed and remove the spool from the spool
housing in the trimmer head.
• Pull the cutting line until it protrudes approximately 5-3/8 inches
(136mm) from the spool. If insufficient cutting line is left on the
spool, install a new spool of cutting line.
• Ensure that the line is not crisscrossed on the spool as detailed
in figure 16. If it is, unwind the cutting line, then wind it back on
the spool neatly so that the lines do not cross.
• Align the tabs on the spool cap with the cut outs in the housing.
• Push the spool cap onto the housing until it snaps securely into
place.
• If the cutting line protrudes beyond the trimming blade, cut it off
so that it just reaches the blade. If the automatic line feed still
does not work or the spool is jammed, try the following
suggestions:
• Carefully clean the spool and housing.
• Remove the spool and check if the lever in the spool housing
can move freely.
• Remove the spool and unwind the cutting line, then wind it on
neatly again. Replace the spool into the housing.
Publicité
