SEVERIN HAIR CARE WL-0801 Mode D'emploi page 10

damage results from improper use, or if
these instructions are not complied with.
∙ This appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural areas,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Operation
Switch settings
The appliance is equipped with a 4-position
switch allowing for the following settings:
0 = Off
1 = Half power / low temperature
2 = Full power / high temperature
❄ = Cool function
Removing and changing the attachments
∙ Always switch the appliance off
and allow it to cool down to room
temperature before changing or
removing any attachments.
∙ To remove an attachment, press and hold
the lock/release button on the housing,
turn the attachment clockwise until the
lock symbols are aligned, and then pull it
off.
∙ To fi t an attachment, follow the same
steps in reverse order while applying only
light pressure, making sure the small lock
symbols (or the dash marks) are aligned.
Lock the attachment in place by turning it
anti-clockwise, when the lock symbol on
the housing and the dash mark should be
aligned.
∙ Without any attachment fi tted, the
appliance can be used as a hair dryer.
10
Round brush
This is useful for giving more volume to the
hair. Position the brush near the roots, and
pull it gently through the hair towards the
ends.
Ceramic round brush
The hot air heats up the metal cylinder so
that the heat can work directly on the hair.
This is helpful when shaping the hair so that
the ends curl inwards or outwards.
Styling nozzle
Attaches to the air-outlet opening and helps
to shape the hair while blow-drying.
Use
∙ The appliance should only be used on
hair that has been dried, and is no more
than slightly damp.
∙ The round brush is designed for shaping
the hair. To achieve this, the hair should be
divided into single strands (not too thick)
and then spread evenly over the brush,
turning them inwards or outwards as
desired.
∙ Apply for a few seconds at a time only,
while letting the hot air take effect on the
hair. Let the strands uncurl afterwards.
Hint:
Using the cool-function before unrolling
the strands will give the hair a fi rmer,
longer-lasting shape.
∙ Let the hair cool down suffi ciently before
brushing it out.
General cleaning an care
∙ Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
∙ To avoid the risk of electric shock, do not