Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged
periods, ensure you take regular breaks.
SYMBOLS
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
Symbol
Signal
DANGER
WARNING
CAUTION
NOTICE
Some of the following symbols may be used on your
tool. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate
the product better and safer.
Symbol
Designation/explanation
Safety alert
To avoid serious personal injury, do not
attempt to use this product until you read
thoroughly and understand completely the
operator's manual.
Beware of thrown or flying objects. Keep all
bystanders (especially children and pets) at
least 15 m away from the work area.
15m
Use unleaded petrol intended for motor vehicle
use with an octane rating of 91 [(R + M)/2] or
higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also each time
before refuelling
English(Original instructions)
Meaning
Indicates an imminently
hazardous situation, which, if not
avoided, will result in death or
serious injury.
Indicates a potentially hazardous
situation, which, if not avoided,
could result in death or serious
injury.
Indicates a potentially hazardous
situation, which, if not avoided,
may result in minor or moderate
injury.
(Without Safety Alert Symbol)
Indicates important information
not related to an injury hazard,
such as a situation that may
result in property damage.
Wear eye and hearing protection when
operating this product.
Do not use metal blade(s) on the product.
Keep hands away from blades.
Start a cold engine.
Start a warm engine.
Rotational direction and maximum speed of
the shaft for the cutting attachment.
12,000
110 110
Guaranteed sound power level is 110 dB.
Conform to all regulatory standards in
the countries in EU where the product is
purchased.
Gost-R conformity
1
1
5
2
2
6
x10
3
4
6
To start a cold engine:
1.
Set the On/Off switch to the ON position ,
2.
Press the primer bulb 10 times or until the fuel fills
the bulb,
3.
Set the choke to the FULL position ,
4.
Pull the starter grip sharply until the engine attempts
to start
NOTE: 6 times Maximum with no throttle
5.
Set the choke lever to RUN position,
6.
Pull the starter grip sharply until the engine starts
NOTE: 4 times Maximum with no throttle
5
3
4
4
Publicité
Table des Matières
