Roger Technology B70/1DCHP Instructions Et Consignes Pour L'installateur page 65

TEST
1 click
CLOSE
11.2
Acquisition procedure:
PROG
AP P-
x4 s
OPENING
• Press and hold PROG for 4 seconds.
• Open the release handle. The message
launches a calibration procedure. The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• Close the release handle. The acquisition procedure now starts.
• is shown on the display (only if parameters
beam within 5 s, to prevent interrupting the procedure.
• is shown on the display and the gate starts opening at low speed.
•
• The gate closes until it reaches the gate closed limit switch.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
• : calibration procedure failed.
• : acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• : travel length error. Press the TEST button to clear the error, and check that gate is completely closed.
ATTENTION: if the acquisition procedure was successful BUT the space between the leaf (stopped at the limit
switch) and the mechanical stop is not as desired, move the limit switch and REPEAT THE ACQUISITION
PROCEDURE. Ensure that AT LEAST 3 centimetres remain between the leaf stop and the mechanical stop.
For more information, see chapter 17 "Alarms and faults".
17 17
da da ta ta
fC fC
PH A5
Wait ...
AU to AU
OPEN
is shown on the display.
appears on the display after a few seconds. The controller unit
TEST
SEE CHAPTER 16 and 17
No
1 click
TEST PROG
No
1 click
Press and hold on
YES
TEST
ACQUISITION
PROCEDURE
CHAP. 11.2
1 click
PH PH A5 A5
to
CLOSING CLOSE
, , , are not disabled). Keep away from the photocell
Until ...
ACQUISITION
AP P- PROCEDURE
CHAP. 11.2
FO TO FO TO
AU to
(if FT are connected
or enabled)
Yes
65