Publicité
Les langues disponibles
Les langues disponibles
Using the dishwasher
Stopping or changing a program
If you want to change program after starting the dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the lid of the detergent dispenser has opened.
Then select a new program, press Start/Stop and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a
while, the dishwasher continues the program.
If the dishwasher is turned off due to a power failure
If the dishwashing program was not finished, the interrupted program continues when power is
restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.
Once the program has finished
The end of the program is indicated by one short signal from the buzzer. The chapter Settings
describes how to change this function.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use.
How to get the best drying results
Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dosage level.
Activate the Auto Open option.
Activate the Extra Dry setting. See the chapter Settings.
Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
18
Publicité
