Siemens TE65F Serie Mode D'emploi page 49

■ Thoroughly clean the inside of the appli-
ance with a moist cloth, removing any
coffee residues.
■ Allow the brewing unit 14 and the inside
of the appliance to dry.
■ Replace the cover 14b on the brewing
unit and then push the brewing unit 14
back into the appliance until it latches into
place.
■ Press the eject lever 15 right up.
■ Slide the red latch 14a all the way to the
right and close the door 13.
Service programmes
F
See also the Quick reference guide in
the storage compartment 16.
Following prior notification, either
Descaling necessary or
Cleaning necessary or
calc'nClean necessary.
appears in display 3 at certain intervals.
The unit should immediately be cleaned or
descaled using the appropriate programme.
The two processes Descale and Clean can
optionally be carried out together using
the calc'nClean function (see the section
"calc'nClean"). Failure to carry out the
service programme according to the instruc-
tions may damage the appliance.
Using a water filter increases the intervals
until a descaling programme needs to be
performed.
F
Important: if descaling is not
performed on the appliance in good
time, then the following appears:
Descaling overdue. Appliance will soon
be locked --> press menu for 3 sec.
Immediately perform the descaling
process in accordance with the
instructions. If the appliance is
locked, it can only be operated again
once the descaling process has been
carried out.
Service programmes
F
Caution!
For each of the service programmes,
use descaling and cleaning agents
as described in the instructions.
Never interrupt a service programme.
Do not swallow any cleaning fluids!
Never use citric acid, vinegar or any
vinegar-based agents. Never place
descaling tablets or other descaling
materials in the coffee drawer 12!
Before starting the service program (Descale,
Clean or calc'nClean) remove the brewing
unit, clean it as instructed and replace it.
Clean the milk system holder 4e thoroughly
to remove any coffee residues.
Specially developed suitable descaling
and cleaning tablets are available from
retail outlets or from customer services
(see the section "Accessories")�
Cleaning the milk system
Takes about 1 minute.
Touch A to open the menu.
■ Use I to choose Cleaning and care
and touch B to confirm your choice.
■ Use I to choose Rinse the milk
system and touch B to confirm your
choice.
■ Touch C to begin running the
programme.
The display 3 will indicate the progress of
the programme:
■ Place an empty glass under the beverage
outlet 4 and stand the end of the suction
pipe 4d in it.
■ Touch C. The milk system will
now clean itself automatically.
■ Then empty the glass and clean the
suction pipe 4d.
You should also regularly clean the milk
system manually (dishwasher or by hand,
see the section "Care and daily cleaning").
Descaling
Takes about 30 minutes.
The line at the bottom of the display
en
49