Kuppersbusch KI6880.1SR Mode D'emploi page 53

EN
stovetop protectors
incorporated into
the device. The use
o f i n a d e q u a t e
p r o t e c t o r s c a n
cause accidents.
It is necessary to
allow the appliance
disconnection after
i n s t a l l a t i o n .
D i s c o n n e c t i o n
devices must be
incorporated to the
fixed electrical
i n s t a l l a t i o n ,
according to the
i n s t a l l a t i o n
regulations.
Caution: The
cooking process
has to be supervised.
A short term cooking
process has to be
s u p e r v i s e d
continuously.
Installation
Installation with cutlery drawer
If you wish to install furniture or
a separation board must be fitted
between the two. Accidental contact
with the hot surface of the device's
housing is thus prevented.
The board must be fitted 18 mm
beneath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
52
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
is installed in the same unit.
Warning:
The electrical connection must
be properly grounded, following
current legislation, otherwise the
induction hob may malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
technical service can handle or repair
the appliance, including replacement
of the power cable.
form the mains, we recommend
waiting for approximately 23 seconds
before disconnecting from the mains.
This time is required to allow for the
complete discharge of the electronic
circuitry and thus preclude the
possibility of electric shock from the
cable terminals.
Keep the Guarantee
Certificate or the technical data
sheet together with the instructions
manual throughout the product's
service life. These contain
important technical information.
About induction
Advantages
transmitted directly to the pan.
This has a number of advantages:
-Saves time.
-Saves energy.
-Easy to clean as if the food comes into
burn easily.
-Improved energy control. The energy
is transferred to the pan as soon as the
as soon as the pan is removed from
stops. It is not necessary to switch the
Pans
Only ferromagnetic pans are suitable for
use with an induction hob.
There are several types:
steel pans specifically for use with
induction hobs.
We do not recommend the use of
Each cooking zone has a minimum pan
detection time. This depends on the
material and the ferromagnetic diameter
of the base of the pan. Therefore it is
essential to use the cooking zone that
best matches the diameter of the base
of the pan to be used.
If the pan is not detected on the selected
zone.
When the Flex Zone is used as a single
Fig. 3
Some pans without a complete
ferromagnetic base are sold as suitable
only the ferromagnetic base is heated.
Consequently the heat is not evenly
distributed across the base of the
pan. This may mean that the non-
ferromagnetic part of the base of the
pan does not reach the right cooking
temperature.