Publicité
Les langues disponibles
Les langues disponibles
5.8 System evaporation
If you have to send the machine back because of a fault or if it has to be transport-
ed, the system can be steamed out. Thus no residual water remains that could run
out during transportation.
Please note:
Only carry out evaporation for the above-mentioned purpose. This is not a cleaning
process that must be repeated regularly.
• Turn the right control knob (3) to «Setting» and press the knob to confirm.
• Turn the right control knob (3) to «Care» and press the knob to confirm.
• Turn the right control knob (3) to «Evaporation» and press the knob to confirm.
• On the display appears «Hose to spout» alternating with «and into drip tray».
• Connect the end of the hose to the spout (4a) and the other end to the drip tray (fig. B).
Tip:
Place a sufficiently large container under the spout (4).
• Press the right control knob (3).
• On the display «Frother is rinsing» appears. Rinsing proceeds automatically and
lasts for about 20 seconds.
• The display shows «remove tank». Remove the water tank.
• The system will now be evaporated and the machine then automatically switches
off.
☛
Remove and thoroughly clean the water tank, the drip tray and the used cof-
fee tray and then put everything back in again.
☛
Carefully pack the machine for shipping, preferably in the original packaging.
No liability can be accepted for damage during transportation.
13_0944_ROT_BA_U2762CH_IH.indd 63
13_0944_ROT_BA_U2762CH_IH.indd 63
63
14.10.13 09:37
14.10.13 09:37
Publicité
